Off Road Equipment has that 5P6222 for $268 used, and the 5P6220 for $335 new. Both OEM and located in Billings, MT.

"d9gdon" wrote:

Off Road Equipment has that 5P6222 for $268 used, and the 5P6220 for $335 new. Both OEM and located in Billings, MT.

Thanks still hoping someone has a cylinder laying around somewhere they would like to part with.

"Billy-" wrote:

The sleeves I used were 5P6222 and 5P6220.

The inner one has a thread in it and screws onto the sprocket retaining nut thread, I then screwed a stud in the end of it (the inner sleeve has a thread in it for this also) and slid the hollow ram over it and retained the end of the stud against the piston of the ram. The outer sleeve slides over the inner one and sits between the cylinder and sprocket. So when you pump the ram, it pushes the outer sleeve against the sprocket thus pushing it on.

Really you only need the inner sleeve that has the threads to screw onto the sprocket retaining nut thread and thread the other end so you can screw a stud into it. The outer sleeve is purely just a spacer and could be easily manufactured - I can measure mine if you want.

Those two that I quoted were only the sleeves per Billy's post, not the cylinder.

"d9gdon" wrote:

Those two that I quoted were only the sleeves per Billy's post, not the cylinder.

Yes sir!

Thanks

The 5P6220 is just a bit of Pipe that is 440mm long with an internal Dia' of 138mm , it's fitted with 2 slotted holes although 1 would be O.K. they start from the end 55mm and run to 165mm with a width of 40mm, any good section pipe with an internal measurement the same or slightly larger would do, these are for working on the D7E through G, the Deadshaft nut needs a 3" socket to undo it, the threads on the Deadshaft are 2"1/8 x 12, the adaptor that fit's onto the Deadshaft is an 8M9013, you can pull and push the Sprocket on via this adapter with a spacer plate behind to pull the rim free, the legs are the short ones 5F9839 x 3, the adapter that screws onto the Service Press is 7M9774 = 100 ton or 5F9888=70 ton, they will both fit either cylinder, the pin Dia' is 1"3/16 and 7/8", there is a press plate that fits into the end of the sleeve (5P6220) that fits onto the cylinder push face. tctractors

Still supprised nobody in the US had a 100ton pulller Laying around for sale.

Hey, Iron Planet is selling two of them today around 2:30 PM. I just came across them.

www.ironplanet.com/jsp/s/item/1544851?h=6-1

www.ironplanet.com/jsp/s/item/1511363?h=6-1

Hope you get one!

Anyone know who got the first one? Second one is still only 60 bucks......and it won't let me sign up.

"Reisingerweld" wrote:

Anyone know who got the first one? Second one is still only 60 bucks......and it won't let me sign up.

It aint 60$ priority bid is way more

I never got to see the first one.

They sold the original Cat press out the back door before the auction...it was there up until about 11AM and then it suddenly disappeared.

The second one, American Hydraulics brand went for $4230! Just a hair over what I wanted to give.

The search continues.