I am looking for 3 items for my 1930 cat Ten:
1.   RH lower engine side panel.  The one below the louvered side panel.  Covers the magneto and governor area.
2.   An undercarriage cross shaft acorn type nut, and washer that goes behind it,  my reprint parts book lists it as the same nut that holds the drive sprockets on. Part # T302
3.   The lower water/antifreeze/coolant pipe from the radiator to the engine. part # T222

thank you

email:   This email address is being protected from spambots. You need JavaScript enabled to view it.

You should be able to make a new lower radiator pipe easily.
First remove the pipe and grind off the welds holding your rusted pipe to the flanges.
Get some 1/2"EMT electrical conduit and bend it to 90deg. Bolt the two flanges on the water pump and lower radiator tank.
Hold the pipe close enough to get a rough size.
Keep marking the pipe removing a little at a time till you can insert the pipe into your flanges.
Tack weld the pipe to the flanges.
remove assembly and finish welding the flanges water tight.
This works for me. My oldest one is still holding after 30yrs this year.
I have new lower side panels if you want to go that route.

I'm interested in a side panel. I pm'd you, and sent email for good measure.  Email me if you did not receive anything.

I think I have located the parts I need from the members here on the forum.  Thanks again.