Mr. Bill and I are going to be parting out this old girl in the near future. Putting out a feeler as to what people need off it. At this moment we are keeping the engine and at least some of the undercarriage. Radiator was good. Track frames and adjusters were getting rotten. Let me know what you need. Located in Coventry, CT not far from UCONN and exit 67 on I-84. 
 

I would be interested in the canopy and the lower grill on this dozer if it were still available. pm sent

Does it have a draw bar? If so what is the distance between the holes where the pin goes?

How bad is the right side under carriage?

Hi guys, sorry I've been MIA. Had some rush jobs at work. We are keeping the UC for our other D6s. It does have a drawbar we would part with, I would have to measure it next time I'm near it. It's stock for a 8U/9U.

Canopy was sold but I'll shoot you a pm with better pics about the lower grill this week.

What's the condition of the head. I'm needing 1 for a D318 in a 20A 977. Call or message Jordan @ 319 231 2777. Thank you.

Claremontcat wrote:

Does it have a draw bar? If so what is the distance between the holes where the pin goes?

 
Not sure if you meant the pin holes or on the drawbar itself. 5.5" on center for pin holes, 9" on center. Pics attached for reference. 

 

catfan wrote:

What's the condition of the head. I'm needing 1 for a D318 in a 20A 977. Call or message Jordan @ 319 231 2777. Thank you.
 

Hey Jordan, I am keeping the engine for my grader. Good luck in your search. 

JoeG wrote:

I would be interested in the canopy and the lower grill on this dozer if it were still available. pm sent
 

 

Hi looking for an oil pan for a 9u?