- Posts: 1411
- Thank you received: 80
ACMOC Membership Benefits
- FREE quarterly magazine filled with content about antique Caterpillar machines
- FREE classified listings
- ACMOC store discounts and specials
- Full Bulletin Board Access
- Marketplace (For Sale/Wanted)
- Technical Library
- Post attachments
$44 /year ELECTRONIC
$60 /year USA
$77 /year International
parts for sale
3 years 4 months ago #229925
by gemdozer
parts for sale was created by gemdozer
Starting engine parts for sale for d2,d4,d6,d7,d8,d9
heads,camshafts,valves,some crankshafts,connecting rods,some magnetos,some carburators,and starting engine transmissions cluch parts
heads,camshafts,valves,some crankshafts,connecting rods,some magnetos,some carburators,and starting engine transmissions cluch parts
Please Log in or Create an account to join the conversation.
- ChrisRoyd2
-
- Offline
- Senior Boarder
- Member
Less
More
- Posts: 61
- Thank you received: 17
3 years 4 months ago - 3 years 4 months ago #229927
by ChrisRoyd2
Replied by ChrisRoyd2 on topic parts for sale
Looking for an eisemann mag for my d4, 2T8965sp
Last edit: 3 years 4 months ago by ChrisRoyd2.
Please Log in or Create an account to join the conversation.
3 years 4 months ago #229932
by gemdozer
Replied by gemdozer on topic parts for sale
I have a used magneto EISEMANN counterclock wise and the cap(plate) is craked and the gear 2a4144 is't on
Please Log in or Create an account to join the conversation.
3 years 4 months ago #230046
by Rat-den
Replied by Rat-den on topic parts for sale
hello what D339 engine parts do you have? im after rings and big end bearings. also rings and bearings for a pony motor on a d7 17a
Please Log in or Create an account to join the conversation.
3 years 4 months ago #230050
by gemdozer
Replied by gemdozer on topic parts for sale
HI For the starting I maybe have some new bearings and ring and not sure about the big motor d339 and need dimention, standar,020,030.
This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in or Create an account to join the conversation.
3 years 3 months ago #230254
by mhar
Replied by mhar on topic parts for sale
any chance you have 2 d2 stamped fenders
Please Log in or Create an account to join the conversation.
3 years 3 months ago #230257
by gemdozer
Replied by gemdozer on topic parts for sale
No stamped fenders
Please Log in or Create an account to join the conversation.
Time to create page: 0.130 seconds
ACMOC
Antique Caterpillar Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
support@acmoc.org
Become a Member!
"I became a member recently because the wealth of knowledge here is priceless."
- Chris R
"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N