I was wondering I& anyone had a hot mag for a RD6 or a D6600 that the6 wanted to sell?

D4600 ? Mag stands straight up? Have one off a 9k cat 12.

oldbeek, the RD6 mag hangs upside down, I reckon it's a Eisemann RC-2Q, someone will confirm
Mike

That is correct.

Yup that’s right. I have 2 Eisemanns but I don’t think I have enough parts between the two to get a functional one. My RD 6 has a Fairbanks Morse on it. Not sure of the type. I am actually needing this one for my 11 grader.

I dismantled 3 magnetos EISEMANNS with a small lever on side maybe could help with parts.

"gemdozer" wrote:

I dismantled 3 magnetos EISEMANNS with a small lever on side maybe could help with parts.

Well I have a good cap that uses a rotor like a distributor. But I don’t Have the rotor. The other cap I have has brushes and is badly corroded. I have 2 good rotors for that cap. My points are good. I also think my coils are good. About 7k ohms and don’t test like they are shorted. I am not sure about the condenser.

I can use a cap or rotor to give me a good set. A coil if you have one that the casing is not split. And if you have a good condenser I will take that as well.

Let me know what you have.

Thanks BJ

I check today and have 1 condensor and rotor and have a cap but when I clean it for checking if he was't crack I found a small hole on no luck.
HECTOR

What rotor do you have? The flat style that goes with the cap that has spring loaded brushes?

My books are showing the RD6 using either the Eisemann GV2Q or the Eisemann RT-2Q.

"Mike wrote:

oldbeek, the RD6 mag hangs upside down, I reckon it's a Eisemann RC-2Q, someone will confirm
Mike