I am looking for new track pads for my wide 28 project . I want pads in near new condition and 18-20 wide , I have some nice rails but will look at all options available . Tractors 20,25,28 ,30,35,and some d-4 ,R-4 will probably fit . thanks scott 1-801-540-8011 or <a href="This email address is being protected from spambots. You need JavaScript enabled to view it." target="_blank">This email address is being protected from spambots. You need JavaScript enabled to view it.

hi Scott this has turned into a really nice project i believe this has the square bolt pattern in the pads and matching rails the later tracks had front and rear bolts spaced out wider i do have some parts cats in my collection and have a complete set of pads of a RD6 i will check the width later we are in full blown harvest mode here right now and my hobby time is limited i will let u know. chuck

Thanks , looking forward to hearing from you.

Well Scot I looked around this AM as it had rained overnite and was too wet to harvest the RD6 pads have the trapazoid bolt pattern and are 16" wide. Howerer i looked at the 6G thirty and also at the D4C the bolt pattern was very similar to the 20 25 and wide 28 so u might be able to expand your search for a source were you looking for the swamp pads made from angle iron or just a normal cat grouser height? i also looked at the off brand TD18 it has the square pattern but the bolts and spacing are too wide maybe a smaller ih would fit hope this might help

Thanks chuck, I'm looking for regular growser pads 16 in wide . I think pads from r4-d4 will work but 3 cylinder are a little bigger bolt pattern .

I also need 1/2 a set of 16 inch pads for a 30 to finish my Dads tractor, His tractor was in a dirt shed for 30+ years and all the pads on the ground are shot.

OK this is making me think about what i have stored in the other barn i wwill look shortly at what i believe to be a R4 parts chassis i will let u know later