I am re-building the bottom rollers on my CAT22, 2F5209. Does anyone know if any of the component parts are still available from CAT, or other sources? If from CAT, have the P/Ns changed? 1B253-Bushing, 1B6619-Shim, V-210-Washer, and 1B265-Washer. Thanks, Ray

Ray--my Cat dealer has them all but they are all indirect replacements so the dealer has to be contacted

"dpendzic" wrote:

Ray--my Cat dealer has them all but they are all indirect replacements so the dealer has to be contacted

Thanks, I'll try Milton CAT to see if they also can get them.

"dpendzic" wrote:

Ray--my Cat dealer has them all but they are all indirect replacements so the dealer has to be contacted

Dan, can you give me the contact information for your dealer so I can contact them. Milton CAT alternative supply guys could not get any of the parts, except for the washers, and those were used at $22 each. New ones are around $30 each. Ray

sure Ray

---

www.hopenn.com/parts/

---

they have a place as far north as Poughkeepsie---I am near the holtsville location on Long Island
Dan

"dpendzic" wrote:

sure Ray

---

www.hopenn.com/parts/

---

they have a place as far north as Poughkeepsie---I am near the holtsville location on Long Island
Dan

Dan,
I called your guy. They cannot get any of the parts either, except for the one washer that Milton can also get. I think I will need to bore out teh existing bushings and sleeve them to take the shaft size. Ray

Ray---try here as i found bushings to fit my D4 blade linkage

---

www.applied.com/categories/bearings/plain-bearings/c/343

also---buntingbearings.com

"dpendzic" wrote:

Ray---try here as i found bushings to fit my D4 blade linkage

---

www.applied.com/categories/bearings/plain-bearings/c/343

also---buntingbearings.com

Thanks, Dan. None of them have bronze bushings with a 2.75" OD, so I think I will have to bore out the existing bushings and sleeve them. If I had thought about it I could have made the new shafts oversized and maybe save having to sleeve the bushings. I'll post what I end up doing. I have had all new shafts made and case hardened. Ray