At the Moment We are in the SAND PIT, Moulding up Gas 35,40,R5 Manifold Casting "ONCE AGAIN", To HELP OUT Buddies of Mine State Side. If any ACMOC Members need any Manifold Parts. This will for SURE be the VERY VERY LAST TIME, Refurbishment of Moulds and Cores etc, To Make a Re-Run, Might of been Easier to Start From "SCRATCH" Again New Tooling instead of Reworking HAMMER Rash and Wear from Previous Work DUN..
Myself and Snr CM, have become well Known this Side in the Foundry World (Close Nit Industry), For our PRECISION Moulding and fitting of Cores, Working in the Tool Room Environment Bedding out Tool Steel Die for 3000 Ton Die-casting Machines for Alu High Volume Production. As helped with Mould Assembly of the Large Inlet Manifolds. The Large Exhaust Manifold is only a One Core Casting, The Inlet is a Complex Large 2 Core Casting with enough Pattern / Moulding / Core Boxes to Fill the Back of a Land Rover.
If Any ACMOC Forum Members want any Gas 35/40/R5 manifolds back to factory data. The Door is Open (Cat-Cave Members [At Cost]. NOTE: + 20 Percent INCREASE For Non Members I.E. ACMOC FORUM). Any Gain (Profit from NON-MEMBERS will go into a pot for a Cat-Cave Members Forum Raffle. All Profit will go into a 1st,2nd,3rd Place Slot. Instead of the Winner Takes it all, Split into 1st,2nd,3rd in rank. Its Not about the Winning, Its the Taking Part that Really Matters.
