I would like to find correct mufflers for my D2 4U that I am restoring, ... can't find a source!

Do any of you guys know of a source for these two little mufflers?

Thanks for any leads.

The following dealer has the D2 muffler.

Part # 3B6217 QTY: 45 NEW NC, US Updated:5/6/2016 GREGORY POOLE EQUIPMENT Phone: (252) 948-3144


Hope this helps..........Bill

"Cysco" wrote:

The following dealer has the D2 muffler.

Part # 3B6217 QTY: 45 NEW NC, US Updated:5/6/2016 GREGORY POOLE EQUIPMENT Phone: (252) 948-3144


Hope this helps..........Bill

THANK YOU very much Bill, .... I will call Greg Poole Monday.

Hope someone also knows of a source for the cute little pony engine muffler .. new or USED!

Thanks again,
Dan

The part you are calling a pony muffler is really an exhaust rain trap.

Here is a source for that part.

8F3824 QTY: 2 *CAT NEW TN, US Updated:5/13/2016 Off Road Eq Parts Phone: (865) 379-7895

I always ask for Dawn....very helpful and knowledgeable.
Hope this helps......Bill

Parts Book shows 3B6232 to Fit D2's and R2's , However it must change to 3B6217 , I have Bought several, ,ask for "Classic parts " they are Cheaper and do the Job just Fine, for memory they were about $60 odd AUD and the Clamp about $27 AUD and were readily available from Dealer out here .
As for the Pony Exhaust / Rain Trap ,I suggested to the ACMOC Board when I was on there that they maybe should look into getting these made as there is a demand for sure , But all these bits take time and Money to Organize . LJ

"Cysco" wrote:

The part you are calling a pony muffler is really an exhaust rain trap.

Here is a source for that part.

8F3824 QTY: 2 *CAT NEW TN, US Updated:5/13/2016 Off Road Eq Parts Phone: (865) 379-7895

I always ask for Dawn....very helpful and knowledgeable.
Hope this helps......Bill

Thank you very much, ... great information. As usual, .. I learned something today !!


I'll call them ASAP.

Dan

"Lance wrote:

Parts Book shows 3B6232 to Fit D2's and R2's , However it must change to 3B6217 , I have Bought several, ,ask for "Classic parts " they are Cheaper and do the Job just Fine, for memory they were about $60 odd AUD and the Clamp about $27 AUD and were readily available from Dealer out here .
As for the Pony Exhaust / Rain Trap ,I suggested to the ACMOC Board when I was on there that they maybe should look into getting these made as there is a demand for sure , But all these bits take time and Money to Organize . LJ

Wow, thank you, I'll call my dealer, I should've asked them but "ASSUMED" it would no longer be stocked by a dealer. My bad!!

Always appreciate the great help here on the board.

Dan

Check your serial #, the early pony rain traps had a smaller inlet than the later ones, at least for the D4's they do. Gary

"Rome wrote:

Check your serial #, the early pony rain traps had a smaller inlet than the later ones, at least for the D4's they do. Gary

OK, I'll check exhaust pipe size, .....thank you.

MY D2 is one of the first 4U's, 1947 production .... 4U 466.

Best,
Dan

Ya it wil probably be the 8F3822 group or the 8F3821 trap part number.