I've decided to sell my d4 t-bar tractors. The first 3 photos are of the 53 model w/ no.64 toolbar. It comes with cat hd chisel set complete with its own toolbar and brackets. It also comes with cat 16' field cultivator with its own bars and brackets. I've had this tractor over 10 years and it runs steers very good.

the last 7 photos are of a 50 model 7u with swing around toolbar blade. no rear implements, only blade. I've had this tractor 17 years. i did a pony rebuild and new piston and liners 15 years back, it hasn't had 200 hours since then. It runs and steers very good. These tractors come with many extra parts not shown in photos. I am 2nd owner of these farmer new bought machines. Both came local and were sold thru hardings equipment in lowell indiana. I'm selling because i can't show or use them anymore and been downsizing to smaller cat projects.


Located NW Indiana, best to call, keyboard doesn't work. 508 333 933six

1953 with no.64 t-bar

1950 7u

i runned the sawmill at pontiac, portland and crown point engine and tractor show using this belt pulley and pto.

rebuilt head

new pistons, liners and valves

lifted for work

Mike do you have any extra shanks for the field cultivator? I would like one more of each short and long shanks.
Thanks
Chuck C

"Chuck wrote:

Mike do you have any extra shanks for the field cultivator? I would like one more of each short and long shanks.
Thanks
Chuck C

i don't, joman might, they're 1" square. cat had special h-d coil mounting to the bar hardware made. i might have some of this special hardware. what coil mounting hardware do u have? john deere is similar but lighter duty/weight. john deere/killifer 1" coils are the same. what points are u using?

Thanks Mike I am using all original Cat hardware that came with the f/c. I am using straight narrow tips on the shanks. I have a set of JD shanks but the sit about 3" lower than the cat shanks. I was thinking of just putting one JD shank on and cutting it to the same size as the Cat shanks and running it without a tip. If I cut it I will lose the mounting bolt holes. I am planning on cultivating 35 acres next month for spring planting.
Thanks
Chuck C

Mike--in your 4th picture down would that be Orrin running it?

"dpendzic" wrote:

Mike--in your 4th picture down would that be Orrin running it?

yep, ol' yankee brakepedal rider. he's doing good i'll be seeing him late april.

Mike---your mailbox is full

"dpendzic" wrote:

Mike---your mailbox is full

ur kidding!!!!!!!! i'll ck.

i'm at library using puter, i have not been getting pm notices. best to call please, i can't keep running to library.

went and got a usb plug in keyboard. good 2 go!

my youngest maybe 14 years ago, i believe he was 14 at the time.