I'm looking for a pony motor or parts. I have one motor but it doesn't have the mounting bracket for the front end, or the manifold for the rear end.
If you need to call me I'm at 502-477-2333...or post an answer and I'll look for it ....They say the 14-A and 15-A and the D-7 all have the same pony motor.
A good friend had a good pony motor that came off this tractor but he sold it for scrap! I hate that! And I also need the crank......

Thanks,

Red

I'm with you, Red. I hate it when an irreplaceable, useable piece of history gets sold for scrap-the couple of bucks netted can't compare to the cost of the loss...even if someone hates pony motors, the principle still applies.

Could you post some pics of your pony and where it mounts on the diesel engine? ...might help better identify what you need.

thanks

I will have a complete pony for a 2U series D8 as soon as I remove it to install my new rebuilt pony. It has one cylinder that fowls the plug within 30 seconds, otherwise it is complete and runs. I know the 2U and the 3T D7 use the same pony but do not know if they fit the 14A and 15A, etc.

The 2u and 3t parts are completed different ,let me have the parts number from the pieces you are looking I have some poney parts for this model

I have 1 crankshaft 8f3755 rebuilt(cut) 20-20 on racking and should have the support 4h5240

The parts for the 15A Pony are the brackets:

4H5324

4H5240

4H5245

Red

"gemdozer" wrote:

I have 1 crankshaft 8f3755 rebuilt(cut) 20-20 on racking and should have the support 4h5240

Gemdozer, if you can find the front bracket 4h5240, let me know what you want for it...

Red

Hey Redsisbest,

I need to pull my 14a pony that blew up in the next week or two. I have a spare. I can't remember if the spare has the right brackets on it or not. Stay tuned, I'll let you know if i can spare my brackets for you.

check with off road equipment in Alcoa tn.

I recheck this morning and the bracket 4h5240 fit on 15a 1 to 3383 serie and am still have 1 bracket 6h5674 fit on 15a1852 to 3383 serie