Does anyone in Oz have a good pair of splined bullgear hubs and rear sprockets to suit the RD4 and D4 7J with the small cap on the end of the dead axle, my splines are just too worn to grab the sprockets tight so I need to find a solution, even if I had to cut and transplant my decent rear sprocket rings onto worn out sprockets provided the inner hub splines of those sprockets were in good condition, part number for the hub is 2B8841 and the sprocket numbers I've seen are 2B8791 on the tractor and 2B9046 in my Parts Book.
Thanks
Mike

Hi Mike, You could also use ones of a 4G or 2T as well as they have the same part No too.

Regards

Hi Daryl, yes you are right, this tractor is actually a early 2T.
Regards
Mike

Try Bill Nicholls at Humula, he has a complete backend, best to talk with his son Jack, 0429 296 665

"Wombat" wrote:

Try Bill Nicholls at Humula, he has a complete backend, best to talk with his son Jack, 0429 296 665

Thanks Neil

Well I just had a nice surprise visit from BruceOz and looking at my hubs and sprockets Bruce thinks I only need one decent sprocket if I get some spacer washers cut and I agree, so if anyone has just one splined D4 sprocket in Oz to suit the older D4's then I'm interested in buying it.
Thanks
Mike

Mike, I tried to call my friend further south who has some, but he is not answering yet but will let you know when i here from him.

Regards

"rax200" wrote:

Mike, I tried to call my friend further south who has some, but he is not answering yet but will let you know when i here from him.

Regards

Thanks Daryl, I appreciate your help, I have emailed Florin about your parts, hopefully Dennis get's back to you today or tomorrow so they can catch my box leaving Monday if you decide to order them.
Regards
Mike