Getting real close to having the d318 for my #12 going. I need a few parts though and was hoping yall could help me out.

4f5019/4f6921/8m9758 Injection Pump X2
2A4871 Yoke for pump
T-308 Stud for pony motor to flywheel
3B9235 starter pinion assembly

These tools would be handy
7F4581
7F4582


Thanks Ryan

Hi,

where are you located, I have some bits around here but I haven't been able to locate any of the part numbers you listed in my parts catalogues, do you have pictures or scans of the parts diagram that you can post up to compare the parts?

"rmyram" wrote:

Hi,

where are you located, I have some bits around here but I haven't been able to locate any of the part numbers you listed in my parts catalogues, do you have pictures or scans of the parts diagram that you can post up to compare the parts?

I am @ 72801 Russellville, AR

Hope the images help, and Thanks for looking!

Hi Ryan I have three D318 engines two complete. One is out of a #12 grader & one is electric start out of a crane & one is a pony start parts engine out of a crane. PM me or call me I can look tomorrow to see if I have all the parts you need. I am in south west Ohio. 937 477 5270 Roger Martin

I have a parts D318 out of a DW10. I don't understand a couple of the parts you are looking for, and the diagram scans are a little difficult to read.

I believe I have the injector pumps, I'll check and get photos tonight. If the 2A4871 yoke you are looking for is the yoke below the pump which drives it, I think I have some of those, too. Not clear which stud for the pony motor to flywheel you're looking for. On the starter pinion, is that the entire assembly? Meaning the housing with clutch, pinion, shaft and drive gear, or is that just the pinion off the shaft?

If you're still looking and can provide some clarification, I'll take a look tonight and photograph what I have available.

Pete.

I don't have any of the parts that you need. Looks like at least you've got a couple better options anyway.

Sorry,

Pete.