acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

Out and About

More
17 years 10 months ago #2524 by Old Magnet
Out and About was created by Old Magnet
Any one ever see a mechanical tilt mechanism like these pics???
New direct start and clutch time on old work horse 2U.
Check the weather guys, this is today and shirts sleeve weather on the central Ca. coast:) :)

Please Log in or Create an account to join the conversation.

More
17 years 10 months ago #2535 by gwhdiesel75
Replied by gwhdiesel75 on topic Out and About
OM - not only does she look like she has done a heck of a lot of work in the past, but her owner is keeping her up so she can do a lot of work in the future. That's the way to treat a Cat! GWH

Please Log in or Create an account to join the conversation.

More
17 years 9 months ago #2558 by MTMike
Replied by MTMike on topic D8 2u
Hey OM I have never seen a tilt like that before what kind is it . Does it work I would like to have one of those for my 2U it would make it real handy not to have to get off ever time you wanted to tilt the Blade It would speed up your work a lot to be able to angle the blade from the seat wow what will they think of next :D Thanks for the Pictures MTMike

Please Log in or Create an account to join the conversation.

More
17 years 9 months ago #2559 by Old Magnet
Replied by Old Magnet on topic Out and About
Hi MTMike,
No, I don't know much about the tilt device. I have never seen another like it. No visible name plate or ID. There is a cover plate access on the outside but all the attachment screws were to buggered up to readily remove. This unit is not currently operating and the power cord (big one) was disconnected. I assume there is an electric motor driven gear drive or ball screw device to make it operate but don't know. I have put a few feelers out to see if someone can supply more info but nothing yet. Yes, it would sure improve blade operation.
I suspect this blade might have been military as they were always big on having the drag rippers installed.

Please Log in or Create an account to join the conversation.

Time to create page: 0.149 seconds
Go to top