Tag on Engine

Mike Hudson
Topic Author
Offline
Senior Boarder
Member

1 year 3 weeks ago #252260 by Mike Hudson

Tag on Engine was created by Mike Hudson

Hello Folks I have a tag on the right side of the engine on my d2 caterpillar. It says .030 rod and main. Am I safe to think it was overhauled with that spec. Thank you. Mike Hudson

Please Log in or Create an account to join the conversation.

D4Jim
Offline
Platinum Boarder
Member

1 year 3 weeks ago #252262 by D4Jim

Replied by D4Jim on topic Tag on Engine

AS an opinion it may be correct or it may not. The only way for certain is to check each rod and main individually. I have seen rebuilt engines that have different regrind diameters within the same block. Then again it may be a professional job with all diameters agreeing with the tag. .

ACMOC Member 27 years
D47U 1950 #10164
Cat 112 1949 #3U1457
Cat 40 Scraper #1W-5494

The following user(s) said Thank You: Mike Hudson

Please Log in or Create an account to join the conversation.

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

ACMOC Membership Benefits

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

Tag on Engine

ACMOC