HomeJoin / RenewChaptersEventsMembersForumAbout
ScholarshipsMachinesDonateYouTube Watch HereGet the FREE Newsletter
acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

  1. Forum
  3. Antique Caterpillar Machinery Owners Club
  5. DISCUSSION
  7. No. 4 Toolbar Hydraulic Cylinder specs

No. 4 Toolbar Hydraulic Cylinder specs

More
1 year 7 months ago - 1 year 7 months ago #247157 by Mike B
No. 4 Toolbar Hydraulic Cylinder specs was created by Mike B
Is there anyone that could measure their cylinder on their #4 toolbar dozer and tell me what the retracted length is pin to pin?  Also the shaft diameter ? Reason for asking is this is a new to me toobar and I think that the current cylinders are not correct. They seem too long. From the parts books that I have access to the correct part #s are 1H813 or 4H6711 or 9F3239 and I can't find any specs for those #'s 
Thanks 
Mike B
Last edit: 1 year 7 months ago by Mike B. Reason: More Info provided

Please Log in or Create an account to join the conversation.

More
1 year 7 months ago - 1 year 7 months ago #247158 by Deebo
Replied by Deebo on topic No. 4 Toolbar Hydraulic Cylinder specs
There’s a couple of no 4 tool bar books in the technical library on the site; not sure if any specs included but might be worth a browse..

 
 
Attachments:
Last edit: 1 year 7 months ago by Deebo. Reason: Typo

Please Log in or Create an account to join the conversation.

More
1 year 7 months ago #247199 by juiceman
Replied by juiceman on topic No. 4 Toolbar Hydraulic Cylinder specs
I went into the dungeon this morning. 20” eye to eye per my worn out Snap-Off tape.
Attachments:

Please Log in or Create an account to join the conversation.

More
1 year 7 months ago #247200 by Mike B
Replied by Mike B on topic No. 4 Toolbar Hydraulic Cylinder specs
Juiceman,
Thanks for taking the time to measure. That is helpful. Mine is 22 3/4. So they are too long. They look to be SWECO cylinders and based on the length they are 12” stroke
Thanks again
Mike B

Please Log in or Create an account to join the conversation.

  1. Forum
  3. Antique Caterpillar Machinery Owners Club
  5. DISCUSSION
  7. No. 4 Toolbar Hydraulic Cylinder specs
Time to create page: 0.148 seconds
Go to top