ACMOC Membership Benefits

FREE quarterly magazine filled with content about antique Caterpillar machines
FREE classified listings
ACMOC store discounts and specials
Full Bulletin Board Access
- Marketplace (For Sale/Wanted)
- Technical Library
- Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

JOIN TODAY! RENEW NOW!

D8 torque convertor output shaft

Start
Prev
1
Next
End

TractorDanD2
Topic Author
Offline
Senior Boarder
User

2 years 3 months ago #240215 by TractorDanD2

D8 torque convertor output shaft was created by TractorDanD2

Can anyone tell me if the torque convertor output shaft be slipped back enough to be able to check the steel seal. Its a D8, serial # unknown at this time. It has a pony start . I was asked this last night and honestly I cant remember if there is enough gap once the u joints and flanges were removed.
Dan

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.129 seconds

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

Go to top