D4 with rear ripper

Deas Plant.
Offline
Platinum Boarder
User

2 years 8 months ago #236529 by Deas Plant.

Replied by Deas Plant. on topic D4 with rear ripper

Hi, Old Magnet.
Yep, the Cat 941 and 951 track loaders had the same arrangement, complete with shims to cater for wear so that you could keep the load concentrated at the drawbar pull point if wear occurred at the drawbar pivot pin under the transmission.

Just my 0.02.

You have a wonderful day. Best wishes. Deas Plant.

The following user(s) said Thank You: Fat Dan

Please Log in or Create an account to join the conversation.

Old Magnet
Offline
Platinum Boarder
Member

2 years 8 months ago - 2 years 8 months ago #236537 by Old Magnet

Replied by Old Magnet on topic D4 with rear ripper

Yes, the 941 and 951 rippers are similar but only the 58Dxxxx series has the "U" model and 12Axxxx mounting group.
The draw bar pin and bracket was not used with the ripper attachments. Front connection was directly bolted to the case bottom where the drawbar pin bracket would be. Shims were used to give some leeway to the fit.

Last edit: 2 years 8 months ago by Old Magnet.

The following user(s) said Thank You: Fat Dan

Please Log in or Create an account to join the conversation.

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

ACMOC Membership Benefits

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

D4 with rear ripper

ACMOC