torque sequence

jw45
Topic Author
Offline
Premium Boarder
User

16 years 3 months ago #19198 by jw45

torque sequence was created by jw45

what is the torque sequence for cyclinder head on d69u also what is the torque for the head bolts thanks jw45

Please Log in or Create an account to join the conversation.

ccjersey
Offline
Platinum Boarder
User

16 years 3 months ago #19199 by ccjersey

Replied by ccjersey on topic torque sequence

Bookmark Willie's page
www.westernfarmcollectables.com/specs.html

The diagram and torque specs from the page above for D318
www.westernfarmcollectables.com/specs3_1.jpg

Where are you in Mississippi?

D2-5J's, D6-9U's, D318 and D333 power units, 12E-99E grader, 922B & 944A wheel loaders, D330C generator set, DW20 water tanker and a bunch of Jersey cows to take care of in my spare time:D

Please Log in or Create an account to join the conversation.

jw45
Topic Author
Offline
Premium Boarder
User

16 years 3 months ago #19223 by jw45

Replied by jw45 on topic where are you

watermelon capital of the world smith county thanks for the reply jw45

Please Log in or Create an account to join the conversation.

SJ
Offline
Platinum Boarder
User

16 years 3 months ago #19239 by SJ

Replied by SJ on topic Torque

I didn,t read CCs procedures but always go 50% torque the first time around and the last time for final torque do the larger bolts first and then the smaller ones last. I always when I got done the second time around would go around the 3rd. time to make sure all were up to specs on their torque.

Please Log in or Create an account to join the conversation.

jw45
Topic Author
Offline
Premium Boarder
User

16 years 3 months ago #19263 by jw45

Replied by jw45 on topic torque

cc instructions gives a 3 tier torqueing sequence detailed really good in the specs thanks for the reply jw45

Please Log in or Create an account to join the conversation.

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

ACMOC Membership Benefits

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

torque sequence

ACMOC