D4400 Injector

John in Wy
Topic Author
Offline
Elite Boarder
User

16 years 5 months ago #17816 by John in Wy

D4400 Injector was created by John in Wy

Changing out an injector. The new one will not seal tight. I have the nut tight but the injector still has some play in it where the pen is pointing. Any ideas? Have a new cork gaskets under the washer. Thanks John

Please Log in or Create an account to join the conversation.

Old Magnet
Offline
Platinum Boarder
Member

16 years 5 months ago #17818 by Old Magnet

Replied by Old Magnet on topic D4400 Injector

Check for a thread problem....that nut looks kind of buggered up and may be bottoming out before closing the gap.

Please Log in or Create an account to join the conversation.

John in Wy
Topic Author
Offline
Elite Boarder
User

16 years 5 months ago #17819 by John in Wy

Replied by John in Wy on topic D4400 Injector

Thanks OM, tried it without the cork gasket and it sealed. So took some fine sandpaper and scrubbed the gasket on it to thin it down and guess what? It is now in place and tight. Now if I could only get that dang #$%@**&^ pony moter to start I might be in bussiness LOL. Thanks, John

Please Log in or Create an account to join the conversation.

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

ACMOC Membership Benefits

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

D4400 Injector

Attachments:

ACMOC