Steering Clutch Control Arm Shaft D42T

bernie
Topic Author
Offline
Platinum Boarder
Member

16 years 5 months ago #17566 by bernie

Steering Clutch Control Arm Shaft D42T was created by bernie

I have a bead on a pair of 1.250 inch STAINLESS STEEL shafts for the steering clutch control arms on my D42T. They are salvage from a boat teardown, so I can get them pretty reasonable and have the end tapped and the holes drilled in them for the cotter pins.

My thought is that this is way overkill and will hold up very well where the pin bearings ride the shaft.

Any thoughts???

bernie

Please Log in or Create an account to join the conversation.

Old Magnet
Offline
Platinum Boarder
Member

16 years 5 months ago #17571 by Old Magnet

Replied by Old Magnet on topic Steering Clutch Control Arm Shaft D42T

Probably work ok......would help to know what type ss it is as some are pretty soft. Also flex/fatigue life might be a concern as ss does not have much of a fatigue/bending cycle life and it's been known to occasionally have one of the original shafts break.
If it's a 316 type I'd say ok but I would be hesitant to use a type 304.

Please Log in or Create an account to join the conversation.

ACMOC

Antique Caterpillar Machinery Owners Club

1115 Madison St NE # 1117
Salem, OR 97301

support@acmoc.org

Chapters History Events Members Contact

Member Quick Links:

Store Forum

Become a Member!

"I became a member recently because the wealth of knowledge here is priceless."
- Chris R

"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
- Jason N

ACMOC Membership Benefits

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

Steering Clutch Control Arm Shaft D42T

ACMOC