acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

questions about 50 head gasket

More
16 years 9 months ago #14306 by STEPHEN
I am looking at my Victor copper jacked head gasket for the gas 50. It is Cat #1A8355. Also stamped on the face is .080 , is this because the gasket was .080" when new?, or does it indicate that it's for an .080" overbore? I also need one good used gasket like it, are there any out there? Thanks

Please Log in or Create an account to join the conversation.

More
16 years 9 months ago #14308 by Willie
The book shows Diff piston numbers up to .080 over but shows only that gasket No.

Please Log in or Create an account to join the conversation.

More
16 years 9 months ago #14312 by STEPHEN
Replied by STEPHEN on topic Thank-you Willie
Thanks, my bore is around +.08 so I was wondering,,,, but then the gasket is at .065 after many years of compression.

Please Log in or Create an account to join the conversation.

More
16 years 9 months ago #14352 by Jason 10/D4
You might try Olsons Gaskets Or even your local cat dealer

Please Log in or Create an account to join the conversation.

Time to create page: 0.150 seconds
Go to top