-
Forum
-
Antique Caterpillar Machinery Owners Club
-
DISCUSSION
-
Caterpillar Eismann Magneto ID Help
Caterpillar Eismann Magneto ID Help
Less
More
-
Posts: 13
-
Thank you received: 0
-
16 years 9 months ago #11574
by D4Dan
I have a few old Eismann Magnetos that I had rebuilt a few years back and I did not label them to what machines they would fit. Im pretty sure the GV-4 is for a Cat Ten, but I am not sure. If anyone knows what machines these magneto models orginally went to, even If not originally Caterpillar, please post or send me an email. thanks! D4Dan
<a href="This email address is being protected from spambots. You need JavaScript enabled to view it." target="_blank">This email address is being protected from spambots. You need JavaScript enabled to view it.
Eismann GV-4 Edition 1
Eismann Type G4 Edition 3
Eismann Type Gs4 Edition 2
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 548
-
Thank you received: 104
-
16 years 9 months ago #11579
by naylorbros
The G4 3rd would have been used on the 10,15 PV,20 L/PL,30 S/PS,60,2-Ton depending on the serial numbers of the tractors. The GV4 would have been used on all of the above except the 2-Ton. The GV4 would have also been used on the latter gas Cats like the 8C 20, 7C 15, 25, 35, etc. up to the time that the CT4 came out. All of the above also depends on the mag rotation and the lag angle of the impulse. For example the G4 3rd on the 2-Ton used the IS-5 impluse and the others were to have the IS-6 impluse used on them. All of the above also depends on the serial number of the tractor that you are working on, please check your parts book for the proper model of mag for your tractor. Hope that helps some.
Thanks
Ken
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 13
-
Thank you received: 0
-
16 years 9 months ago #11580
by D4Dan
thanks Ken, we sold our tractor collection and was just going through some stuff to see what I have left. thanks for the info. Dan
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 13
-
Thank you received: 0
-
-
Forum
-
Antique Caterpillar Machinery Owners Club
-
DISCUSSION
-
Caterpillar Eismann Magneto ID Help
Time to create page: 0.135 seconds