Just recently aquired a small 15 that runs but is in somewhat rough condition. Is Rankin Developement the place to get tinwork, seatbox, fenders, lower side panels, etc. Who else if anyone makes reproduction tinwork? Any recommendations or advice appreciated. Thanks, tailseat22

Steve Weaver who goes by Side-seat on this website also makes the tin.

This guy is into the business of making sheet metal for older Cat tractors so give him a call. Geo Logue 120 S.Arch St. Montoursville Pa.17754 & Ph. is (570) 368-2639 & fax is (570) 368-2858 Montoursville is in N. Central Pa. near Williamsport Pa.

I bought a complete set from Steve Weaver, excellent quality and he delivered it to The Brownsville show in pennsylvania.

Tailseat 22,
If you want the seat assembly for your 7C to be original it was riveted, not bolted. I got mine from George Rankin. I talked him into putting the seat assembly together using rivets like from the factory. It came out just like an original. He said it was a tough job and never wanted to do another one again. But that's been four or five years ago. Maybe, he'll change his mind. Good luck with your 7C, Frank

The radii on the lower corners look alittle small. they should be 2''rad. Nice tractor anyhow!