I just got one of those myself (from Tornado parts, Medina.Ohio) to experiment with but haven't got around to messing with it yet. They are a very common pump for the engines after the "U" models. The one thing I would want to incorporate is that it take suction from at least primary filtered fuel so I have selected a primary filter to use where I can tap in this pump. The other thing I'm a little concerned about is that this pump is a very low volume output compared to the ones used on the D311/D315/D318 engines so it may take a lot of pumping to get the job done.
Thanks OM. I had already added a filter/water sep between the tank and the transfer pump back when I got the D2 12 years ago. What size fittings does this pump have on it?
Kevin
In/out is 1/8 inch NPT.
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Fifteen
| Placerville, CAChapter Two
| Stradsett, Nr Downham Market. Norfolk PE33 9HA UKChapter Two
| Faulkner Farm, West Drove, Wisbech, Cambridgeshire, PE14 7DP, UK
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I became a member recently because the wealth of knowledge here is priceless."
-Chris R
