So the owner already had a new used idler for the 8, but its not the same one, the one off the machine is a 8f-1978, the new one is a 9h7521, the new one doesnt have the same mounting blocks on the side, also there are no grease fittings, is this one oil filled and sealed? Can the mounting blocks be removed and swapped?
I am't sure but should't have the same shaft and bearing should't fitt on
Any ideas? Do the blocks just press off? I may try and find a press to use if nothing else
The block bearing 8f1978 should be just press on shaft
Good to know! So knowing that info, im going to try and get the block off probably friday and get them swapped over
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Nineteen
| Cnr Hiller Lane and Ballarat Road, Hamilton, Vic, 3300Chapter Two
| Pitt Farm, Little Paxton, St Neots, Cambridgeshire, PE19 6HD, UKChapter Fifteen
| Historic Santa Margarita Ranch, 20000 El Camino Real, Santa Margarita, CA 93453, USAChapter Thirty
| Hartley - South Australia
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I became a member recently because the wealth of knowledge here is priceless."
-Chris R
