D7 17a #11060

If you get stuck for Cat rails (chains?) Komatsu D65 rails are the same. I fitted them to a 17A and they are within millimetres of the Cat rails/chains and run fine.

There's a thread on here with the details some where.

http://www.acmoc.org/bb/showthread.php?24724-D7-17a/page2

The 8.00" pitch D6, 963 and Komatsu D60, D65 and D66 all use the same Cat link assemblies.
Check the number of link assemblies required.
Dimensions of the D7 links are a little different on a few items but certainly close enough to work.
Otherwise you are limited to rails from the 7M, 3T, 17A.

The 8.00" pitch D6, 963 and Komatsu D60, D65 and D66 all use the same Cat link assemblies.
Check the number of link assemblies required.
Dimensions of the D7 links are a little different on a few items but certainly close enough to work.
Otherwise you are limited to rails from the 7M, 3T, 17A.

[quote="Old Magnet"]The 8.00" pitch D6, 963 and Komatsu D60, D65 and D66 all use the same Cat link assemblies.
Check the number of link assemblies required.
Dimensions of the D7 links are a little different on a few items but certainly close enough to work.
Otherwise you are limited to rails from the 7M, 3T, 17A.[/quote]

Magnet,
will the track plates fit the Komatsu chains?

Note says Cat & Komatsu shoe bolt hole patterns are not interchangeable.