D4400 Injector

Showing 1 to 2 of 2 results

John in Wy

Topic Author

Offline

Send a private message to John in Wy

Posts: 191

Thank you received: 0

Changing out an injector. The new one will not seal tight. I have the nut tight but the injector still has some play in it where the pen is pointing. Any ideas? Have a new cork gaskets under the washer. Thanks John
Attachment

Please log in or create an account to join the conversation.

Mon, Jun 16, 2008 3:07 AM

Old Magnet

Offline

Send a private message to Old Magnet

Posts: 16,694

Thank you received: 16

Check for a thread problem....that nut looks kind of buggered up and may be bottoming out before closing the gap.

Please log in or create an account to join the conversation.

Mon, Jun 16, 2008 5:05 AM

John in Wy

Topic Author

Offline

Send a private message to John in Wy

Posts: 191

Thank you received: 0

Reply to Old Magnet:

Check for a thread problem....that nut looks kind of buggered up and may be bottoming out before closing the gap.

Thanks OM, tried it without the cork gasket and it sealed. So took some fine sandpaper and scrubbed the gasket on it to thin it down and guess what? It is now in place and tight. Now if I could only get that dang #$%@**&^ pony moter to start I might be in bussiness LOL. Thanks, John

Please log in or create an account to join the conversation.

Mon, Jun 16, 2008 5:12 AM

Showing 1 to 2 of 2 results

Follow Us on Social Media

Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.