Sprocket only removal requires:
5F7334 spacer group (1)
5F9040 Arm Group (3)
7F9831 cylinder group (1)
Thanks so you have to pull final drive off and then pull sprocket
If you wish to pull the final drive and sprocket assembly and have a shop do the pressing that is an alternative. Or you can pull the sprocket only after splitting the track and removing the track frame and outer bearing hub and bearing holder. Are you dealing with a spoke type or disc type sprocket? Be wise to get yourself a service manual.
been doing this a long time just the service manual says to pull the final off and then press the sprocket off I never done a 5 just 6,7,8,and 9s on those you have a adapter that screws on to the dead axle to attach the press to and I don't see that adapter
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Fifteen
| Placerville, CAChapter Two
| Stradsett, Nr Downham Market. Norfolk PE33 9HA UKChapter Two
| Faulkner Farm, West Drove, Wisbech, Cambridgeshire, PE14 7DP, UK
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I became a member recently because the wealth of knowledge here is priceless."
-Chris R
