Does the frog or bowl have an extra set of holes in it? Or the cutting should have two rows of holes?, you just take the bolts out and lower the edge.
The 4T6626 is the current number for the 8C 70 (stinger arrangement)
Length 55.38"
Width 13"
Thickness 0.88"
1-row, 16 holes (off center)
What I do not understand is that the existing edge is curved about 1 inch. Not top to bottom but side to side. The new edge is straight.
If the bolt pattern matches for the straight cutting edge you may have to cut it in half to fit the curve surface. Not sure if a large power hack saw, band saw would cut it, or else a matabo.
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Nineteen
| Cnr Hiller Lane and Ballarat Road, Hamilton, Vic, 3300Chapter Two
| Pitt Farm, Little Paxton, St Neots, Cambridgeshire, PE19 6HD, UKChapter Fifteen
| Historic Santa Margarita Ranch, 20000 El Camino Real, Santa Margarita, CA 93453, USAChapter Thirty
| Hartley - South Australia
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
-Jason N
