3pt Hitch on 951C

Showing 1 to 2 of 2 results

Aphonopelma

Topic Author

Offline

Send a private message to Aphonopelma

Posts: 170

Thank you received: 0

Has anyone ever designed or built a 3pt linkage to use the existing 4 pin ripper attachment points on a 951C? I have seen OM's very nice 3pt setup on his D4. Thanks

Scott

1975 951C

Please log in or create an account to join the conversation.

Wed, Nov 9, 2011 2:17 AM

Old Magnet

Offline

Send a private message to Old Magnet

Posts: 16,694

Thank you received: 16

Nope, never have seen one adapted from the 4 link system. Did look into a 955 unit to get ideas on the drawbar attachment below. My requirement was to run a PTO which those rippers with center mounted cylinder would not accomodate. Whatever you build, make it beefy, as at some point a good portion of the tractor weight may be supported on the hitch.

Please log in or create an account to join the conversation.

Thu, Nov 10, 2011 12:14 AM

dutchoven

Offline

Send a private message to dutchoven

Posts: 10

Thank you received: 0

could you link me to the d4 with the three point hitch you refer to. thanks

Please log in or create an account to join the conversation.

Mon, Oct 31, 2016 5:58 AM

Showing 1 to 2 of 2 results

Follow Us on Social Media

Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.