I have a pile of toolbar stuff that’s been sitting in my buddy’s junk pile for a few years time to pass it on. No 4 with clamps and a 64 with clamps. 2 cat rectangular bars, 1 IH rectangular bar all in the 10 - 12 foot length. 3 J&T forged ripper shanks in the 30” depth range. I also have a set of homemade steel gauge wheels that go with the J&T ripper shanks.
Package deal, make offer.
Located in San Joaquin County, CA these are heavy, you would need to load and haul away. Place is usually in inaccessible due to mud sometime in November through April depending on weather cycle.
CR,
Sent you a message
Mike
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Nineteen
| Victoria Park, Urana NSWChapter Nineteen
| 1234 Carngham-Lake Goldsmith Rd, Lake Goldsmith VicChapter Nineteen
| 2 Winkleigh Rd, Exeter TAS 7275
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
-Jason N