4th
I have parts books, seal installers and a few parts from a sprocket press also but don't want to drive other peoples post down will try to figure out how to load multiple pictures
Greg
what kind of sprocket press parts and seal installers do you have . Anything for the Cat D7E 47a or 48a's ? Thanks
Bryan Costley
Seal installers for crank shafts 3306 3406 and others
Do not have much left from the press lent it out and did not get most of it back
Ok thanks , I have most of the same sprocket press parts that you have .
Bryan Costley
Is that the 3 pulling arms on the shelf, behind the adapters ? Thanks
Bryan Costley
Yes
31 inch center on the holes
Greg
Do you want to sell them ? By themselves or all of the sprocket press tools .I know I could use the bars but not sure anything else Let me know what you want for them . Where are you located? thanks Bryan Costley
Bryan Costley
Would like to move it all together
But make me a reasonable on any or all of it
I am in Westchester county N/Y
Greg
Thanks Greg , How about 350.00 for what you have left of the sprocket puller tools . Plus shipping of course ?
Bryan Costley
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Twenty Nine
| Hawkesbury Showground, Racecourse Rd, Clarendin, NSW, AustraliaChapter Eighteen
| Geoff Ralph Drive, Taabinga, 4610, Kingaroy, Qld.Chapter Thirty
| 3429 Copper Coast Highway Paskeville, SA 5572Chapter Nineteen
| Victoria Park, Urana NSW
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
-Jason N