D9G Torque settings

hello Neil ,the service book has not any torque for the draw bar bolts,if you post the bolts size i can post the torque for the bolt size ,bruce oz

1'' = 500-600 pound feet
1 1/8''= 675-825 pf
1 1/4''=860-1060 pf
1 3/8''=1050-1290 pf
1 1/2''=1260-1540 pf


.

Hello Bruce

I am not close to the machine but I do know the nuts measure 2 3/8" across the flats- the studs are 1 1/4" diameter.
Hope this helps
Thanks
Neil

hello Neil ,use this size for your bolts -1 1/4''=860-1060 pf,
clean all the surfaces ,sand rust off , ,put the bolts in the brackets ,leave bolts loose until the clevis and bolts are installed ,tighten bracket bolts(trans) first ,then clevis bolts.
bruce oz

That is much appreciated imformation, thanks very much Bruce

Neil

Hello Neil,
D-9G service book says 1 1\2" studs.
studs torque 550 lb. ft. nuts 1500 lb. ft.
good luck
Bob

Hi Niel,
Now ya'll got me looking.
Should be on that copy of the rear case parts diagram I sent you earlier.
I show the studs to be a #9S7479......unfortunately I don't seem to have a size chart up to that size to identify them with.

Universal torque chart.