[attachment=58048]image.jpg[/attachment]From the TEN parts book [attachment=58047]E7239606-A78B-428D-B91E-A5033F639E05.jpg[/attachment]
Nice pictures
Hello all:
We have the parts manuals. What we need is photographs of the fittings, lines and valves that we can match or reproduce. Ours was missing all of the plumbing parts and we want to get it as close to stock as possible. Any thoughts would be greatly appreciated!
When I restored my Ten it had a woven brass thread fuel line covered with fabric. I assume it was the original line. The two original valves were bad, but the new ones I found were real close. I replaced the brass line with rubber. M
Here is a picture of some of the parts.....I have the old fuel lines and I think the valves but can't locate them at this time.
The fuel tank pads are woven all cotton 1-1/4" wide x 4" long.....in other words it's kerosene lantern wick material. I found some NOS ones so I know this for a fact.
Hope this helps......Bill
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Nineteen
| 5875 STH GIPPSLAND HWY, NYORAChapter Thirty
| Booleroo Centre, 54 Arthur St, Booleroo Centre SA 5482, AustraliaChapter Fifteen
| Tulare, CaliforniaChapter Nineteen
| 34 Henty Hwy, Warracknabeal
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I also joined a year ago. had been on here a couple of times as a non-member and found the info very helpful so I got a one year subscription (not very expensive at all) to try it out. I really like all the resources on here so I just got a three year. I think its a very small price for what you can get out of this site."
-Jason N
