button head grease gun?

 [attachment=67688]FA526D98-B12F-4E55-B8C9-C9EF822C07F4.png[/attachment] Should use a grease volume pump with 00 grease 
You can use your grease gun you have to have an adapter to go on the button head and a fitting on the other end to connect to your grease gun.  But be careful you can blow the seals out. 

I found a grease gun that only does about 2k psi and used a button head adapter. Even still, you have to be careful and stop pumping as soon as you feel pressure in the handle, or you will blow out the seals as Skinner said above.

Thanks for the information 😁👍

i purchased a button head applicator and installed it on a good lever type grease gun with a hose. i but the cornhead grease in the tubes just like regular grease. the only thing is you need to pump and feel the pressure build and stop before you blow the seals. it is very obvious to feel or get the over pressure relief valve and install on the buttonhead tip.

 [attachment=67689]1312ECBD-8F72-4207-8B61-6FA016C9E2BD.jpeg[/attachment]Adapter 

https://www.ebay.com/itm/284678386028?chn=ps&norover=1&mkevt=1&mkrid=711-213727-13078-0&mkcid=2&itemid=284678386028&targetid=4580496732614414&device=c&mktype=&googleloc=&poi=&campaignid=418233788&mkgroupid=1230353745471221&rlsatarget=pla-4580496732614414&abcId=9300542&merchantid=51291&msclkid=225e99a1ba921be398b1fbd4fbf9925a

this is what i use----but i get it at the JD dealer

you can buy semi fluid grease. not all guns will pump it. also make sure the cup is around the right way as it has to be reversed if you are using bulk grease. most 450gram guns are set for cartridges. ngli 000 grease is almost runny. caltex had a grease called EPC in ngli grade 000 it was popular in australian coal mines as a track lube. multifak ep is the new name.

alemite and mcnuaght both supply adapters for the 7/8 button heads and the cheapest place to buy the fittings is the dealer the local dealer charged us $7.50ea compared to ordering from alemite at $21.00ea

if you think the fitting is blocked simply remove it and have a poke around with a skewer to see if the grease has hardened.

you can get modern style grease relief valves set for a range of pressures and with a few fittings and the adapter could make a relief adapter for roller greasing.