Original was 1B2346, or now it's two 3H1397 or CR15141 or Timken 51098 back to back is what I have written here for the #41 I'm about to fit to my D2 5U
Thanks Mike
Chuck C
[quote="ChuckC"]Thanks Mike
Chuck C[/quote]
Glad I could help Chuck, I just pulled that 1B2346 seal out of my pump this afternoon, so will need to get a replacement organised myself.
Mike
Hey guys don't mean to hijack the thread too much but I have a D2 with a serial number of 005U03173 and a power unit labled as 4W-178. I too have a seal leak up front and was getting ready to pull it apart. Can someone help guide me in the right direction for the part numbers I may need for the seal or seals? I haven't contacted CAT yet just read this post and figured I may as well ask.
Welcome to ACMOC, I took my pump to my local hydraulic shop and they fitted new bearings and a seal, the NTN bearings were only about $7.
Mike
Speaking of serial numbers, if the tag is gone off my #44, is there a stamped number somewhere on it?
Our channel highlights machines from the earliest Holt and Best track-type tractors, equipment from the start of Caterpillar in 1925, up to units built in the mid-1960s.
Chapter Nineteen
| 5875 STH GIPPSLAND HWY, NYORAChapter Thirty
| Booleroo Centre, 54 Arthur St, Booleroo Centre SA 5482, AustraliaChapter Fifteen
| Tulare, CaliforniaChapter Nineteen
| 34 Henty Hwy, Warracknabeal
Antique Caterpillar
Machinery Owners Club
1115 Madison St NE # 1117
Salem, OR 97301
Terms & Privacy
Website developed by
AdCo
"I became a member recently because the wealth of knowledge here is priceless."
-Chris R
