#2 Tool bar and #42 tool bar

I believe the difference u'll find will be the diameter of the pins and the bolts. 3/4" bolts for the d2, 7/8 bolts for the d4 if i member right.

[img]https://i.postimg.cc/NFskB3Zf/SAM_1214.jpg[/img]

[quote="ag-mike"]I believe the difference u'll find will be the diameter of the pins and the bolts. 3/4" bolts for the d2, 7/8 bolts for the d4 if i member right.

[img]https://i.postimg.cc/NFskB3Zf/SAM_1214.jpg[/img][/quote]
Thanks for the reply Mike.

I need to remove the large vertical pin. Looks like an interfearance fit and may have to be drilled out. was just wondering if anyone else has had success pressing it out off the cast yoke.

I don't remember any of it being "interference fit", rusted internally for sure.

Mike, do you have the part number for the larger yoke part that sits on top of the beam.
It has 7/8 bolts through it and the vertical pin is 1.5 inch diameter

Regrets, no. i sold all my t-bar stuff and gave away parts manuals.

If that's for the D4 with 7-1/2 x 4-1l2 beam the bracket is a 1J218 with 8F3697 pin.

If that's for the D4 with 7-1/2 x 4-1l2 beam the bracket is a 1J218 with 8F3697 pin.