T-564 Reproduction hand crank that fits the small gas cat tractors. Made in the USA with ductile iron. Limited supplies. Makes a good stocking stuffer! $125 plus shipping. 307-760-8483

Looks nice, are the larger ones for the 28 and 30 in the works, I need one of each.

Steve A, 30 hand cranks or next on my plate. 20/25/28/R3 handcranks are way down the line.

Hello Chad,
Nice work on the reproduction. That part number T-564 is also the part number for the hand crank used on the J series D2's. The handle assembly is great, but what about rest of it? For the J series D2 it calls for a shaft assembly #4B6374. Wonder if the crank assembly T-564 included the 4B6374 and all the attaching parts?

Dozerman51,
Thanks for the question. What is pictured is what you get. All of those other parts mount in the radiator shell and the later ones only from the outside. This assembly would have been installed and used to turn the diesel engine or index the crankshaft to a specific position for tasks such as pump timing, pump lift setting or valve adjustments. If you need any of those other parts email and we can discuss me making them up as well. <a href="This email address is being protected from spambots. You need JavaScript enabled to view it." target="_blank">This email address is being protected from spambots. You need JavaScript enabled to view it. Thanks again!

Chad, Nice work! Will the tin handles on the cranks be available as replacements for sixty steering clutch levers as well? If so what will be the cost of those?

Hi chad,nice work, I'm a little confused though as in the the listing you said the part number is T-564 and in the pics it looks like the part number stamped on the handle is T156. Is this correct?? I am in need of one as I have just tighten mine up to much and snapped a lug off it. I'm gutted.
Thanks stew

The part number of T-564 "assembly" broken down into its basic parts, The casting number on the crank is T-156 the tin handle that I asked about will be 1781-A the steel center hand crank handle which I do not have the number for will have its own number.

&quot;8D-132&quot; wrote:

The part number of T-564 &quot;assembly&quot; broken down into its basic parts, The casting number on the crank is T-156 the tin handle that I asked about will be 1781-A the steel center hand crank handle which I do not have the number for will have its own number.

Thats great thank you. I was confused.
Thanks stew

8D-132, Right now all of the spinners that I am making are being installed in handcrank castings. Once I get done with those I can make you some spinners, no problem.

Stew, send me an email if you would like to order a hand crank. I need your address again.

Thanks!